Cutting Interior Wall Panels
Two days ago I tried to cut the plywood for the walls and only got as far as two before what I would consider complete disaster struck. Today however, I cut 8 walls out and not one was a wasted piece.
To cut these panels the right size I used a cardboard stencil of the curve in the ceiling and traced it onto the plywood. Our walls are as straight as we could get them but, not perfectly straight as I found out last time I tried to cut the walls. This time, I used only a stencil of the angle with a line drawn on it to show the line of the outside 2x2 and drew in the lower part of the wall by using a lot of measurements. Above is the disastrous wall panel from the other day, I cut it for one side, re-cut it for the other, and then attempted to fit it in above the wheel well… i'm still not sure what went wrong with the measurements for it but it just never seemed to fit anywhere.
Today went much smoother however, I focused on one side of the bus, and as you can see, banged them out one after another.
Well, Phil, I hope you like the new walls :)